Tweet
I was just curious if this coil here would work for the window motor one day when I get that far. I had an old SAE-400 Lincoln stick welder with a gas motor in it that went out so I took the thing apart and that's where I got this from. I have 2 of them. 
I was thinking it might work for a small window motor. What do you guys think?
-
-
Hi Buz86,Originally posted by Buz86 View Post
check for the wire size inside.. too much thick and it may require external current limiting to it..other than that it should not be a problem..
Rgds,
Faraday88.'Wisdom comes from living out of the knowledge.' -
I want to say it is 26 awg. At one point I thought I checked it with my digital micrometer and I took that decimal figure and it was in range for 26awg. Would that be too thick?Comment
-
Hi Buz86,Originally posted by Buz86 View Post
That should be good enough..go ahead..better still if you get one more such type of a coil loop... you may place it at 90 degree position like in the Original Bedini Window motor with the black globe.
Rgds,
Faraday88.'Wisdom comes from living out of the knowledge.'Comment
-
What is the measured resistance across this coil...? As that will tell you what size transistors to use in the Bedini / Cole Bipolar H-bridge driver circuit for it
and if you have another one like that one, that would be very good for 2 winding's at 90deg from each other, and a 4 Pole NSNS rotor Window MotorComment
-
I measured it and it was 9.6. Is this too much resistance? And I thought I had two but I found the other one today. It was about 1 foot away and connected to a spool that I started winding it around a couple years ago when I first got them. Back then I just saved it because I figured I could get a few hundred feet of magnet wire out of it. So I want to say the other twin is probably about 3/4 or less of what you see in the one in the picture above. The rest of it is wrapped around a big spool but since I never cut it, I suppose I could always just unwind it and wrap it back into the same shape it was originally in like the one in the picture above.Comment
-
no that is not too much resistance...... and if you put the other one back, you will have 2 nice window motor coils......
I think that the MJL21193 - 4's will work good as the H bridge transistors........Comment
Comment