Find the sweet spot

[kingstingtin]

Today switched its coil mode attraction.
Next, I tried to configure the device according to the method that described in the manual by John K (Page 18 of 25).
Obtained the following results:
I'm in a panic, all is lost! Sweet has no place.
What should I do, help me please.

[kingstingtin]

Though, everything is logical.
More revolutions per minute, the more pulses per minute. Hence, the current will be greater. Then what's the point? Do not understand anything.

[BEDINSSGUKRAINE]

Konstantin, do you use the same battery as it was in your previous runs ?

Once again, what you looking for is large amount of short sharp impulses with minimum power usage on the primary battery during wheel spinning.
The battery charging is a long process, see my post here on forum, don't give up man.
You should charge battery many times and then discharge it many times too, sometimes the voltage increase is minimum, but if you do this on schedule you should able to achieve some results or use another battery (for me that was a case)

[John_Koorn]

Today switched its coil mode attraction.
Next, I tried to configure the device according to the method that described in the manual by John K (Page 18 of 25).
Obtained the following results:[ATTACH=CONFIG]2027[/ATTACH]
I'm in a panic, all is lost! Sweet has no place.
What should I do, help me please.

Which manual by me?

John K.

[kingstingtin]

Which manual by me?

John K.

I so have understood that it is written by you: Bedini Monopole 3 Group Experiment V1.01.pdf
If not, then I apologize.

[kingstingtin]

BEDINSSGUKRAINE, I bought a new battery (Varta 12N5.5-3B, 12V 6Ah, Art.506 011 004).
In the third cycle, he again began to decrease capacity. To avoid this, I need to constantly increase the voltage termination charge.
This has happened despite fact that I discharged him only 25%.
By analyzing the resulting graph, now I reached it to absurdity. I had driven deep into mode of self-excitation my device.

[BEDINSSGUKRAINE]

Konstantin you wont see real results after 3rd charging, you need atleast 15 charge and discharge cycles!
Did you watched my videos?

[John_Koorn]

I so have understood that it is written by you: [ATTACH]2029[/ATTACH]
If not, then I apologize.

Yes, that was one of mine.

John K.

[BEDINSSGUKRAINE]

John_Koorn
I have a question about this manual, i think it would be great if this document would mentioned that better explanation can be found in new SSG books created by Peter Lindermann and Aaron Murakami. I think than many beginners mistakes can be avoided.

[kingstingtin]

Yes, that was one of mine.

John K.

John, there is what is wrong, or I can fully trust your manual?

Regards, Konstantin.

[John_Koorn]

Sorry guys, I don't understand what your question is.

John K.

[kingstingtin]

John, your manual contains an error? Or I can do everything as stated in it and get the correct result?

[BEDINSSGUKRAINE]

John_Koorn
Sorry, i would say following due to large amount of new stuff which is on the net your manual is not up to date, large portion of your manual is good, but some hint's are mssing like for example how to examine the battery charge, at which point the battery starts with better voltage or that coil should be in fix stable position. Picture of right Scope with radiant impulse this would help me a lot! Some improvement to your manual are needed.

[John_Koorn]

I don't think that manual contains any errors, if you follow it you will get a working SG. Hundreds of people have working SGs by following that manual. Some sections may need updating, it is what, 4 years old or something? If I had to re-write it, which I probably won't, I would update it with what I have learnt since then.
Give me some specific examples of what you think is wrong and I'll happily clarify for you.

John K.

[kingstingtin]

Thanks John, that's all I wanted to hear. I did not mean to say that there is something wrong, just wanted to make sure that I'm on the right track.