These are the magnets I am using: Ceramic Magnets 1-7/8" X 7/8" x 3/8" Block - Set of 2 - Amazon.com
They are C8 ceramic magnets, 3850 gauss approximate pull force: 4.5 lbs magnetized through the thickness. My little screwdriver will stay attracted to the bottom of the rods to about 1/2" spacing, then it falls off...but again...my RPM's suck at that spacing and I can't find my sweet spot anymore.
Lemme do some testing with your suggestions...let me know if you think there's anything else going on. I'll post a close up of the board later his evening.
Thanks!
They are C8 ceramic magnets, 3850 gauss approximate pull force: 4.5 lbs magnetized through the thickness. My little screwdriver will stay attracted to the bottom of the rods to about 1/2" spacing, then it falls off...but again...my RPM's suck at that spacing and I can't find my sweet spot anymore.
Lemme do some testing with your suggestions...let me know if you think there's anything else going on. I'll post a close up of the board later his evening.
Thanks!
Comment